Skip to main content
Skip table of contents

Cluster configuration

To use Elastic Search in cluster configure file config\elasticsearch.yml for every node as followed

  • Set the cluster name.
    cluster-name=SomeClusterName
  • Set the first node name.
    node.name=SomeNodeName

  • Set node will act as a master.
    node.master=true

  • Set node will act as a data-node.
    node.data=true

  • Set first node’s ip and port
    network.host=IpOrUrl
    http.port=9200 (or any other port)

  • Cluster nodes discovery protocol and list of nodes (except current node)
    discovery.zen.ping.unicast.hosts: ["IpOrUrl_0", "IpOrUrl_1"]

  • Set any other parameters (path to indexes etc) in Elastic Search configuration file

After all nodes are configured start it.

To verify is all nodes in cluster are configured properly use the command

CODE
curl -XGET 'http://IpOrHost:9200_OrConfiguredPort/_cluster/state?pretty'



JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.