Skip to main content
Skip table of contents

Updating a Job Processor

  • Be sure to stop both, the SAF Server and the SAF Administration application before starting the new setup.
  • Run the setup.
  • If your Job Processor was running as service before, then shut down the SAF Server started during setup.
  • Wait 60 seconds.
  • Go to Service Control Manager and start the service for your Job Processor.

Port is already in use

Due to the way TCP/IP works, connections can not be closed immediately by the operating system. Packets may arrive out of order or be retransmitted after the connection has been closed. CLOSE_WAIT indicates that the remote endpoint (other side of the connection) has closed the connection. TIME_WAIT indicates that local endpoint (this side) has closed the connection. The connection is being kept around so that any delayed packets can be matched to the connection and handled appropriately. The connections will be latest removed when they time out within four minutes.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.