Mixtreme: Fatal communication error with device
The error box states the following:
The software Mixtreme.exe determined with communication with the driver of the card (level meter data, status, not Streaming) that the card gave an implausible answer. Therefore Mixtreme.exe is terminated. The actual problem behind this is the Motorola DSP on the Mixtreme card. The DSP also accommodates the PCI interface and there lies the chip's weaknesses. In the early mask revision 3F48S the deficiencies are fairly serious, therefore it is suggested that Mixtreme's with this DSP should be avoided. With the current mask revision 2K30A, the problem arises actually only with exotic chip sets.
So it is essential to clarify which mask revision is being implemented. In the case of the 3F48S, then there is the possibility of soldering a additional PLL chip to the card which improves the situation. If this is also not helpful, one can try to adjust the PCI Latency Counter so that the card runs with longer bursts. Should this also not improve the situation, one can attempt to use the Mixtreme.exe only for setting the configuration. There is a command line parameter, that causes the software to terminate immediately after starting and loading the settings.
If your Mixtreme card implements a 2K30A mask revision, then this is a relatively clear indication that the Mainboard operates on the border of the specifications. Here one can also try to adjust the PCI Latency Counter more generously and terminate the Mixtreme.exe immediately.
*****DEUTSCH*****
Die Fehlerbox sagt folgendes aus:
Die Software Mixtreme.exe hat bei der Kommunikation mit dem Treiber
der Karte (Levelmeter-Daten, Status, nicht Streaming) festgestellt, dass
die Karte eine unplausible Antwort gegeben hat. Deshalb beendet sich
Mixtreme.exe. Das eigentliche Problem dahinter ist der Motorola DSP
auf der Mixtreme-Karte. Der DSP beherbergt auch das PCI-Interface
und genau da hat der Chip Schwächen. In der früheren Maskenrevision
3F48S sind die Mängel relativ gravierend, weshalb von Mixtremes mit
diesen DSPs abzuraten ist. Mit der aktuellen Maskenrevision 2K30A
tritt das Problem eigentlich nur mit exotischen Chipsätzen auf.
Also zunächst muss geklärt werden, um welche Maskenrevision es sich
handelt. Ist es die 3F48S, so besteht die Möglichkeit einen extra PLL-Chip
einzulöten, der die Situation verbessert. Nützt auch das nichts, kann
versucht werden, den PCI Latency Counter so einzustellen, dass die Karte
längere Bursts fahren kann. Nützt auch das nichts kann noch versucht
werden, die Mixtreme.exe nur zum Einstellen der Konfiguration zu benutzen.
Es gibt einen Kommandozeilenparameter, der die Software dazu veranlasst
sich beim Start sofort nach dem Laden der Einstellungen wieder zu beenden.
Handelt es sich um eine 2K30A Mixtreme und das Problem tritt auf, so ist
dies ein relativ deutliches Zeichen dafür, dass das Mainboard am Rande
der Spec arbeitet. Auch hier kann noch versucht werden den PCI Latency
Counter großzügiger einzustellen und die Mixtreme.exe gleich zu beenden.